User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Figure 6:5 Attaching the Bracket to the Pole
1.2. Tighten the bolts so that the bracket will not move. The recommended
maximum torque is 24 N/m (17.7 ft/ lbs). I f your LibraPlus has an
integrated antenna, as shown in the figure below, do not tighten the
mounting clamp bolts unit you have aligned your antenna.
1.3. Bolt the mounting bracket’s unit anchor to the unit’s housing, as shown in
the figure below. Tighten the bolts so that they are snug. Do not over
tighten the bolts, as they could crack the housing. The recommended
maximum torque is 5.7 N/ m (17.7 ft/ lbs).
Figure 6:6 Attaching the Bracket to the radio
1.4. Secure the unit to the pole, as shown in the figure below.
LibraPlus 5860 User Guide LibraPlus I nstallation: Pole-mounting the LibraPlus Page 31 of 95