User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Figure 6:7 Securing the radio to the pole
1.5. Tighten the pivot nut and bolt. The recommended maximum torque is 24
N/m (17.7 ft/ lbs). If your LibraPlus radio has an integrated antenna, do not
tighten the pivot nut and bolt until you have aligned your antenna.
6.6
Wall-mounting the LibraPlus Radio
1. To mount your LibraPlus radio to a wall:
1.1. Prepare the wall to hold the mounting bracket. The type of mount you
create will depend upon the type of wall surface and material your wall is
made of. I t may be that you only need to drill holes and insert bolt
anchors, or you may have to fabricate a strong mount that will withstand
the unit’s weight, outside temperature change, or other variables. For this
reason, EI ON requires that you supply your own fastening bolts, lag-
screws, or other fastening devices.
1.2. Place the back of the bracket against the wall mount, as shown below.
Figure 6:8 Bolting the Wall-side Bracket to the Wall
1.3. Secure the mounting bracket to the wall, using the necessary bolts.
LibraPlus 5860 User Guide LibraPlus I nstallation: Wall-mounting the LibraPlus Radio Page 32 of 95