User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
1.4. Bolt the bracket’s unit anchor to the housing, as shown below.
Figure 6:9 Attaching the Bracket to the radio
1.5. Tighten the bolts so that they are snug. Do not over tighten the bolts, as
they could crack the housing. The recommended maximum torque is 5.7
N/m (4.2 ft/lbs).
1.6. Connect the radio to the mounted wall-side bracket, using the pivot arm,
as shown below. I f your LibraPlus radio has an integrated antenna, do not
tighten the pivot nuts and bolts unit you have aligned your antenna.
Figure 6:10 Bolting the radio to the Wall Bracket
LibraPlus 5860 User Guide LibraPlus I nstallation: Wall-mounting the LibraPlus Radio Page 33 of 95