User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Figure 6:12 Complete Cabling Diagram
6.9
Cabling up to the LibraPlus Radio
Cabling from your indoor terminal equipment (PoE) to your radio is straightforward. To
cable your LibraPlus radio:
• Mount the radio’s power inserter on the wall, close to the cable’s exit point
from the building. How you mount the power inserter will depend upon certain
issues, such as the type of wall surface and material your wall is made of.
• Connect an Ethernet cable from your terminal equipment to the Data port of
your radio’s power inserter, as shown in the f igure below.
LibraPlus 5860 User Guide LibraPlus I nstallation: Cabling up to the LibraPlus Radio Page 35 of 95