User's Manual

WARNI NG: Power I nserters may have different labeling
applied to the unit. See the diagrams below to determine
the appropriate ports to connect the equipment.
Figure 6:13 Connecting an Ethernet Cable to the Pow er I nserter
Figure 6:14 Alternate PoE Labeling
• Install the round ferrite bead on the RJ45 Ethernet cable on the end close to
the power inserter.
• Connect the LibraPlus Radio’s Ethernet/ power cable to the Data and Power port
of your power inserter, as shown in the f igure above.
Note: use crossover Ethernet cable in Data port (unless Laptop/ PC is
used), and a straight cable in Data+ Power port of PoE.
• Install a Ethernet CAT-5 in-line surge protector on the Ethernet/ Power cable,
before the Ethernet/ Power cable exits the building.
• Ground the surge protector to a common earth ground, outside the building,
per the manufacturer’s instructions. This surge suppressor is not weatherproof,
so it must be installed inside the building.
• Run the Ethernet/ power cable out of the exit point of the building to the
outside.
• Install the round ferrite bead on the RJ45 Ethernet cable on the end close to
I n
p
ut = Data
p
ort
Insert LibraPlus
side here
Output = Data &
Power
Insert Local LAN
side here
LibraPlus 5860 User Guide LibraPlus I nstallation: Cabling up to the LibraPlus Radio Page 36 of 95