User's Manual

the figure below.
Figure 6:22 Connecting the RF Cable to the LibraPlus Radio
2. Weatherproof the cable connection, as outlined in Weatherproof ing Cable
Connections section above.
3. Connect the surge suppressor to the cable, per the manufacturer’s instructions.
Selection of the lightning protector should be of the Non DC Pass as this will
also aid in the prevention of static discharge damaging the equipment or
degrading performance by introducing noise to the receiver portion of the
outdoor unit.
4. Weatherproof the suppressor connection, as outlined in Weatherproofing Cable
Connections section above.
5. Connect the cable from the surge suppressor to the antenna, per the antenna
manufacturer’s instructions.
6. Weatherproof the suppressor connection, as outlined in Weatherproofing Cable
Connections section above.
7. Ground the suppressor to a common earth ground, per the manufacturer's
instructions.
6.13 Connecting the Power/ Ethernet to the LibraPlus
Once the LibraPlus has been installed and cabled, you should connect the power to the
unit’s power inserter and check that it is operating correctly.
6.13.1 AC Pow er
To plug your power inserter into an AC mains outlet:
1. Plug the power cord into the power inserter, as shown in the figure below.
LibraPlus 5860 User Guide LibraPlus Installation: Connecting the Power/ Ethernet to the LibraPlusPage 40 of 95