User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Figure 7:4 Wireless Settings at Slave (p2p)
7.2.1.1
Wireless Settings - Field Descriptions
Field Name Description
Device
Operation
Mode
This is the mode in which the system can operate. For Point-to-
Point LibraPlus radios (RD and ER), the available modes are
“Master” and “Slave”.
If “Master” is selected then the LibraPlus 5860 acts as a Radio
Access Point. I f “Slave” is selected then the LibraPlus acts as a
Radio Station.
Depending on the Mode selection, the below conf igurable
parameters will change.
The default mode is “Master”.
Note: It is advised to select the operating mode before selecting
other wireless parameters
LibraPlus 5860 User Guide Conf iguration: Wireless Page 46 of 95