User's Manual

Field Name Description
Station I D
( SSI D)
This is the SSI D of the radio. SSI D is a string parameter which can
be a maximum of 32 characters.
The default SSI D is “target”.
For Point-to-Point operation, only a single SSI D can be configured.
Multiple SSI D is a Point-to-Multipoint feature.
Mode The radio can operate on two different modes. They are “Normal”
(20 MHz channel width) and “Turbo” (40 MHz channel width).
Depending on the selected mode, the channel list below will
change. Only certain channels can operate on “Normal” and
“Turbo” respectively.
The default mode is “Normal”.
Note: Always select the “Mode” before selecting the “channel”.
Note: Mode should always be selected at the Slave, even though
the channels are in auto scan mode
Channel This is the list of available channels. The channel list changes
depending on the “Mode” selected. For the channel vs. frequency
mapping please check the right side of the “Wireless Settings”
screen.
The default channel is “36”.
Note: The Slave is in “auto scan” mode always
Transmit
Power
This is the transmit power of the radio in dBm. The maximum
transmit power changes depending on the channel selected. For
the Maximum transmit power on a given channel, please check the
right side of the “Wireless Settings” screen.
The user can select any of the power settings between 1 and the
maximum power per channel. The user can also select the “auto”
option.
The default average Transmit Power is “14” dBm.
I MPORTANT: Actual power output can vary greatly
depending on the modulation and channel size.
Note: The Slave is in “auto” mode always
Data Rate This is the Data Rate of the radio. The user could select any one of
the value shown in the drop down box.
The default Data Rate would be “auto”
Wireless
Transmission
This setting toggles the radio on and off.
The Default is Radio “ON”.
LibraPlus 5860 User Guide Conf iguration: Wireless Page 47 of 95