User's Manual

7.2.2 Wireless Encryption
This is the conf iguration procedure to conf igure the wireless encryptions on the
LibraPlus5860 product.
1. Log into the LibraPlus 5860 GUI and click the “+ ” sign near the “Wireless” at
the left side of the page. After pressing the “+ ” sign”, the “wireless” will expand
showing “Wireless Settings” and “Wireless Encryption”.
2. Now click the “Wireless Encryption” Select the “Authentication Type” in this
page. The type could be “WEP” or “WPA” or “None”.
3. If user selects “WEP”, then automatically “Encryption Phrase” text will be
displayed. The user can enter the “encryption phrase”. The encryption phrase
can be maximum 5 characters.
4. If the user selects “WPA”, then automatically “Auth Mode” and “Encryption
Phrase” text boxes will appear. Here the user can select the “Auth Mode”
(option of “TKIP or “CCMP) and enter the encryption phrase. The encryption
phrase should be between 5 and 13 characters. The Default is be “None”
Note: I f user selects the authentication in the Master, then the user
should select the same authentication and the key at the Slave.
5. Once the parameters are selected, click the “Apply” button below
6. Any change in the wireless encryption parameters to take effect it requires a
reboot. So the system will ask for the options “Save and Reboot” or “Save” or
“Cancel”.
7. If the user presses “Save and Reboot”, then the conf igurations is going to get
saved and reboot the system
8. If the user presses “Save” then the conf iguration will get saved, but not
functionally active. This would become active in the next reboot
9. If the user presses “Cancel” then there is no effect.
Figure 7:5 Wireless Security without Encryption
Figure 7:6 Wireless Security with WEP Enabled
LibraPlus 5860 User Guide Conf iguration: Wireless Page 49 of 95