User's Manual

Figure 7:7 Wireless Security with WPA Enabled
7.2.2.1 Wireless Security - Field Descriptions
Field Name Description
Authentication
Type
This is the type of authentication which the user is choosing.
This can be “None”, “WEP” or “WAP”.
The default is “None”.
Auth Mode This is the authentication mode which the user needs to select.
The possible “Auth Mode” are “TKIP” and “CCMP”. This
parameter will appear only when the user selects “WAP”
authentication type.
The default is “TKIP”.
Encryption Phrase This is the encryption key which the user needs to enter if the
user selects “WEP” or WPA” encryption type.
Note: WEP allows only 5-13 characters. WPA allows 8 to 63
characters.
7.3 Network I nterfaces
7.3.1 Bridge Settings
This is the conf iguration procedure to conf igure the bridge settings of the LibraPlus
5860 product.
1. After logging into the LibraPlus 5860 GUI, click the “+ ” sign near the “Network
Interfaces” at the left side of the page.
2. After pressing the “+ ” sign”, the “Network I nterfaces” will expand showing
“Bridge”.
3. Now click on “Bridge”
4. Any of the parameters list in the “Bridge” page can be changed. Once the
bridge parameters are changed, click the “Apply” button below.
5. These changes take effect immediately without reboot.
LibraPlus 5860 User Guide Conf iguration: Network I nterfaces Page 50 of 95