User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Figure 7:8 Bridge Settings
7.3.1.1
Bridge Settings – Field Descriptions
Field Name Description
Bridge MAC
Address
This is the MAC address of the bridge. This cannot be changed.
BRI DGE MTU This is the Bridge MTU. Bridge MTU takes values from 576 to
2290.
The default Bridge MTU is “1568”.
Bridge Ageing This value is the Ageing of the bridge learnt entries in seconds.
The default ageing period is “300” seconds.
7.3.2 Bridge Multicast Settings
This is the conf iguration procedure to configure the bridge multicast settings of the
LibraPlus 5860 product
1. After logging into the LibraPlus Product, click the “+ ” sign near the “Network
Interfaces” at the left side of the page.
2. After pressing the “+ ” sign”, the “Network I nterfaces” will expand showing
“Bridge”. Now click on the “+ ” sign near the “Bridge”.
3. Click on “Multicast”.
4. It will show the option of “Enable” or “Disable”. The default is “Enable”.
5. Once the bridge multicast option is chosen click the “Apply” button below. This
setting takes effect immediately without reboot.
Figure 7:9 Bridge Multicast Settings
LibraPlus 5860 User Guide Conf iguration: Network I nterfaces Page 51 of 95