User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
7.3.2.1
Bridge Multicast – Field Descriptions
Field Name Description
Multicast This is the f ield which enables or disables the multicast
traff ic passing through.
The default is “Enable”
7.3.3 Management Settings
This is the conf iguration procedure to conf igure the management settings of the
LibraPlus 5860 product.
1. After logging into the LibraPlus 5860 Product, click the “+ ” sign near the
“Network Interfaces” at the left side of the page.
2. After pressing the “+ ” sign”, the “Network I nterfaces” will expand showing
“Management”.
3. Now click on “Management”
4. Any of the parameters listed in the “Management” page can be changed
5. Once the Management parameters are changed click the “Apply” button below.
This setting takes effect immediately without reboot.
Figure 7:10 Management Settings
7.3.3.1
Management Settings – Field Descriptions
Field Name Description
Management I P
Address
This is the management I P address of the Radio.
The default Management I P address is “192.168.1.44”
Note: users should not use I P address 192.168.1.40 or the
subnet 192.168.3.0/24 because these addresses have been
reserved for internal purposes.
Management Subnet
Mask
This is the management subnet mask of the Radio.
The default Management Subnet Mask is “255.255.255.0”
LibraPlus 5860 User Guide Conf iguration: Network I nterfaces Page 52 of 95