User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Field Name Description
Management VLAN This is the option to enable or disable the Management
VLAN
The default Management VLAN setting is “Disable”
Management VLAN
I D
This is the Management VLAN I D. This value should be in
the range between 1 and 4095.
7.3.4 Gateway and Hostname Settings
This is the conf iguration procedure to conf igure the Gateway IP address and the
Hostname of the LibraPlus 5860 product.
1. After logging into the LibraPlus 5860 Product, click the “+ ” sign near the
“Network Interfaces” at the left side of the page.
2. After pressing the “+ ” sign”, the “Network I nterfaces” will expand showing
“Gateway & Hostname”.
3. Now click on “Gateway & Hostname”.
4. Any of the parameters listed in the “Gateway & Hostname” page can be
changed.
5. Once the Management parameters are changed click the “Apply” button below.
This setting takes effect immediately without reboot.
Figure 7:11 Gatew ay and Hostname Settings
Field Name Description
Default Gateway
I P Address
This is the Default gate IP for the radio.
There is no default gateway IP conf igured.
Note: The Default Gateway IP Address should belong to the
same subnet as the management IP address.
Hostname This is the hostname of the radio.
The default Hostname is “target”
7.4
Network Services
7.4.1 DHCP Server Settings
This is the conf iguration procedure to conf igure the DHCP server parameters of the
LibraPlus 5860 User Guide Conf iguration: Network Services Page 53 of 95