User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
LibraPlus 5860 product.
1. After logging into the LibraPlus Product, click the “+ ” sign near the “Network
Services” at the left side of the page.
2. After pressing the “+ ” sign”, the “Network Services” will expand showing
“DHCP-SERVER”. Now click on the “DHCP-SERVER”
Note: This link will be show n only in the “Master” mode
3. Any of the parameters listed in the “DHCP-SERVER” page can be changed
4. Once the DHCP server parameters are changed click the “Apply” button below.
Figure 7:12 DHCP Server Settings
7.4.1.1
DHCP Server Settings – Field Descriptions
Field Name Description
DHCP I nterface This is the interface on which the DHCP server runs on.
This would be running only on the “bridge” interface.
User will not be able to change this parameter.
DHCP Service This is to enable or disable the DHCP Server.
The default is “Disable”
Subnet Mask DHCP subnet mask
Start I P DHCP start I P
Note: This IP should be on the same subnet as the
bridge IP
End I P DHCP End IP
Gateway I P DHCP Gateway IP
LibraPlus 5860 User Guide Conf iguration: Network Services Page 54 of 95