User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
DNS Server I P DHCP DNS server IP
Domain Name DHCP domain name
Lease Time This is the renew lease time in seconds
Min. number of Leases DHCP Minimum leases
Max. number of Leases DHCP Maximum leases
7.4.2 DHCP Client Settings
This is the conf iguration procedure to conf igure the DHCP client parameters of the
LibraPlus 5860 product.
1. After logging into the LibraPlus 5860 Product, click the “+ ” sign near the
“Network Services” at the left side of the page.
2. After pressing the “+ ” sign”, the “Network Services” will expand showing
“DHCP-CLIENT”.
3. Now click on “DHCP-CLIENT”
Note: This link will be show n only in the “Slave” mode
4. DHCP client can be enabled or disabled
5. Once the DHCP client enabled or disabled click the “Apply” button below.
Figure 7:13 DHCP Client Settings
Field Name Description
DHCP Services This is to enable or disable the DHCP client.
The default is “Disable”
7.4.3 SNMP Settings
This is the conf iguration procedure to conf igure the SNMP parameters of the LibraPlus
5860 product.
1. After logging into the LibraPlus 5860 product, click the “+ ” sign near the
“Network Services” at the left side of the page.
2. After pressing the “+ ” sign”, the “Network Services” will expand showing
“SNMP”.
3. Now click the “SNMP”.
4. The user can change the required parameters in the SNMP.
5. Once the SNMP parameters are modified click the “Apply” button below. This
need a save and reboot to get the changes to be in effect.
LibraPlus 5860 User Guide Conf iguration: Network Services Page 55 of 95