User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
Timer”.
3. Now click on “Watchdog Timer”
4. The user can “Enable” or “Disable” watchdog timer. The user also can also
change the watchdog expiry timer value.
5. Once the Watchdog conf iguration is done click the “Apply” button below. I f
watchdog timer value is changed, then it will take effect on the next save and
reboot.
Figure 7:16 Watchdog Timer Settings
7.5.2.1
Watchdog Timer – Field Descriptions
Field Name Description
Watchdog Timer This field is to Enable or Disable Watchdog Timer.
The default value is “Disable”.
Note: If the watchdog timer is disabled, then the LibraPlus
5860 will request a reboot.
Watchdog Expiry
Timer
This is the watchdog timer value in seconds.
The default value is “60” seconds.
Note: If the timer is changed the changes will not take effect
until the next reboot.
7.5.3 MAC Access List Settings
This is the conf iguration procedure to conf igure the MAC Access List parameters of the
LibraPlus 5860 product.
1. After logging into the LibraPlus 5860 Product, click the “+ ” sign near the
“System” at the left side of the page.
2. After pressing the “+ ” sign”, the “System” will expand showing “MAC Access
List”. Now click on the “MAC Access List”
3. The user can create and new MAC Access List name, by entering the access list
name in the “MAC Access List Name” box and click the create button
4. All the MAC Access List Name will appear in the “Add MAC Access Entries”
table. The user can choose the “MAC Access List Name” and enter the MAC
entries for that particular MAC Access List Name.
5. Once the MAC Access List Entries are configured click the “Add” button below
to add the MAC Address to a particular MAC Access List. I f the user wants to
LibraPlus 5860 User Guide Conf iguration: System Page 58 of 95