User's Manual
Table Of Contents
- 1 Copyright Notice
- 2 Table of Contents
- 3 Preface
- 4 Product Description
- 5 Pre-installation
- 6 LibraPlus Installation
- 6.1 Connecting the Ethernet Cable
- 6.2 Mounting Conditions
- 6.3 External Antenna Mounting
- 6.4 Integrated Antenna Mounting
- 6.5 Pole-mounting the LibraPlus
- 6.6 Wall-mounting the LibraPlus Radio
- 6.7 Antenna Mounting Guidelines
- 6.8 Cabling the LibraPlus
- 6.9 Cabling up to the LibraPlus Radio
- 6.10 Weatherproofing Cable Connections
- 6.11 Installing a Drip Loop
- 6.12 Cabling to the Antenna
- 6.13 Connecting the Power/Ethernet to the LibraPlus
- 7 Configuration
- 8 Monitoring Status
- 9 Utilities
- 10 Appendix A: Troubleshooting
- 11 Appendix B: Definitions
- 12 Appendix C: 5 GHz US Channel Spacing
- 13 Appendix D: Integrated Antenna Specifications
I ndication Possible Cause Corrective Action
High packet loss Signal to strength too
low
• Record RSSI to determine
fade margin
• Check for obstacles in RF path
• Check for interference
• Point antenna in different
directions to take advantage
of benef icial multipaths
• Reposition antenna to
establish better LOS
• Replace LibraPlus and perform
bench test
High packet loss Interference
• Change center frequency
• Increase RF power
• Change polarization of
antennas
• Get separation or change
physical location of antenna
High packet loss Temperature
• Determine if ambient
operating temperature is too
high or low
• Increase or reduce ambient
temperature
LibraPlus 5860 User Guide Appendix A: Troubleshooting: Troubleshooting Chart Page 76 of 95