Manual

Page 3 of 12
Drawing : - TPC302
Issue : - 7
Date : - 10/12/13
INTRODUCTION
Designed for a wide range of applications, the CS60 dehumidifier is a rugged,
industrial unit which utilizes an energy-efficient compressor and a compact
portable design to provide easy efficient drying.
The CS60 has a number of special features:
• Compact Size
• High efficiency rotary compressor
• Ebac’s “Hot Gas” defrost system
• Exterior epoxy powder-coated finish
• Provision for permanent drainage
• All galvanized interior
• Extra long power cord
• Humidistat
The fan draws the moist air through the cold evaporator coil, which cools the
air below its dew point. Moisture forms on the evaporator coil and is collected
in the condensate tray, which is equipped with a permanent drain. The cooled
air then passes through the hot condenser coil where it is reheated using the
same energy removed during the cooling phase, plus the additional heat
generated by the compressor. The air is, therefore, discharged from the
dehumidifier at a slightly higher temperature with a lower absolute humidity
than that which entered. Continuous circulation of air through the
dehumidifier gradually reduces the relative humidity within the area.
The CS60 dehumidifier is a rugged, reliable drying unit designed to operate
effectively over a broad range of temperature and humidity conditions. An
active hot gas defrost system, controlled by an electronic timer, guarantees
positive de-icing, thereby optimizing operation at low temperatures.
The unit incorporates a welded and galvanized steel chassis and is finished in
an epoxy coating for resilience to damage caused by rough handling.