Drawing : - TPC209 Issue :-6 Date : - 09/12/13 NEPTUNE INDUSTRIAL DEHUMIDIFIER OWNER’S MANUAL www.eipl.co.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 NEPTUNE PACKAGE CONTENTS Item Description Quantity 10199GR-US Dehumidifier 1 3014336 PVC Tube – 3/8” I/D 1.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 INTRODUCTION Designed for a wide range of applications, the Neptune dehumidifier is a super high capacity industrial unit which provides fast and efficient drying.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 SPECIFICATIONS MODEL: Neptune HEIGHT: 24” (610mm) WIDTH: 14” (355mm) DEPTH: 15” (381mm) WEIGHT: 60 lbs (30 Kg) AIRFLOW: 282 CFM (476 M3/Hr) POWER SUPPLY: 110V/ 60Hz/ 1 ph FINISH: Powder-coated Epoxy OPERATING RANGE: 33°F – 95°F REFRIGERANT: R-407c (16.2 oz) "This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. The refrigeration system is hermetically sealed.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 OPERATION The following procedures should be followed to test the Neptune for correct operation: 1. After unpacking, examine all external features to confirm damagefree shipment. Report all defects and damage at once. Connect the power cable to a grounded 15 Amp electrical outlet. 2. Check dehumidification process as follows: CAUTION: DO NOT REMOVE COVERS WHEN UNIT IS IN OPERATION A. Place unit on a level surface. B. Start up unit by switching to “ON”. C.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 ROUTINE MAINTENANCE WARNING: ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE MAINTNENANCE To ensure continued full efficiency of the dehumidifier, maintenance procedures should be performed as follows: 1. Replace or clean the inlet air grille as required. Clean the surface of the evaporator and condenser coils by blowing the dirt out from behind the fins with compressed air.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 REPAIRS 1. Should an electrical component fail, consult the Factory Service Center to obtain the proper replacement part. 2. If refrigerant gas is lost from the machine, it will be necessary to use a refrigeration technician to correct the fault. Contact the Factory Service Center prior to initiating this action. Any competent refrigeration technician will be able to service the equipment. The following procedure must be used: a.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 TROUBLESHOOTING SYMPTOM Unit inoperative Little or no airflow CAUSE 1. No power to unit 1. Loose fan on shaft 2. Fan motor burnt out 3. Dirty refrigeration coils 4. Loose electrical wiring Little or no water extraction 1. Insufficient air flow 2. Compressor fault 3. Loss of refrigerant gas Little or no defrost when required 1. Faulty timer 2. Faulty by-pass valve Unit vibrates excessively 1. Loose compressor 2.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 NEPTUNE SPARE PARTS LIST NUMBER DESCRIPTION 1 Compressor (RGA5456EXA) 2 Compressor Overheat Protector 3 PART NUMBER QUANTITY 3022170 1 N/A 1 Compressor Capacitor 3030908 1 4 Evaporator/Condenser Coil 2139330 1 5 Black Rubber Foot 3101436 4 6 Filter Dryer 3020901 1 7 Fan Motor 3035788 1 8 By-pass Valve 3020811 1 9 Electronic Timer 1609850 1 10 Axial Fan 3040129 1 11 Rocker Switch 3035914 1 12 Thermistor Assy 30
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 Ebac LIMITED WARRANTY Our products carry a one-year unconditional warranty against any defects in workmanship or material. This warranty will cover all parts and labour required to repair your Ebac product. This warranty is invalid if the unit has been abused, damaged, whether intentional or accidental, or if any modifications have been made to the unit.
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 Page 11 of 16
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 Page 12 of 16
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 Page 13 of 16
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 Page 14 of 16
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 Page 15 of 16
Drawing : - TPC209 Issue :-6 Date : - 09/12/13 UK Head Office American Sales Office German Sales Office Ebac Industrial Products Ltd St Helens Trading Estate Bishop Auckland County Durham DL14 9AD Ebac Industrial Products Inc 700 Thimble Shoals Blvd. Suite 109, Newport News Virginia, 23606-2575 USA Ebac Industrial Products Ltd. Gartenfelder Str.