Drawing : - TPC448 Issue :-3 Date : - 24/11/16 RM4500 INDUSTRIAL DEHUMIDIFIER OWNER’S MANUAL www.eipl.co.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 INTRODUCTION Designed for a wide range of applications, the RM4500 is a rugged, industrial unit, which utilizes an energy-efficient compressor and a compact portable design to provide easy efficient drying.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 SPECIFICATIONS MODEL: 10570RH-GB HEIGHT: 1115 mm WIDTH: 625 mm DEPTH: 710 mm WEIGHT: 77 kg AIRFLOW: 600 M3/Hr POWER SUPPLY: 230V/ 50Hz/ 1 ph FINISH: Rotational Moulded polyethylene OPERATING RANGE: 3°C – 35°C REFRIGERANT: R407c (650g) "This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. The refrigeration system is hermetically sealed.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 OPERATION The following procedures should be followed to test the RM4500 for correct operation: 1. After unpacking, examine all external features to confirm damage-free shipment. Report all defects and damage at once. Connect the power cable to a grounded 13 Amp electrical outlet. Connect the drainage outlet to a suitably sized hose and run the hose to a permanent drain. 2.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 F. When the unit is operated in ambient of less than 15°C, a defrost cycle should occur approximately every 20mins. The exact time is impossible to predict as the unit is fitted with a temperature sensitive defrost control. When the unit is defrosting, the % Relative Humidity displayed on the digital controller may increase as a result of the ice / frost melting.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 ROUTINE SERVICE WARNING: ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE SERVICE. THE SERVICING AND REPAIR OF THIS UNIT SHOULD ONLY BE CARRIED OUT BY A SUITABLY QUALIFIED PERSON. To ensure continued full efficiency of the dehumidifier, maintenance procedures should be performed as follows: 1. Clean the surface of the evaporator and condenser coils by blowing the dirt out from behind the fins with compressed air.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 REPAIRS 1. Should an electrical component fail, consult the Factory Service Center to obtain the proper replacement part. 2. If refrigerant gas is lost from the machine, it will be necessary to use a refrigeration technician to correct the fault. Contact the Factory Service Center prior to initiating this action. Any competent refrigeration technician will be able to service the equipment. The following procedure must be used: a.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 TROUBLESHOOTING SYMPTOM CAUSE Unit inoperative 1. No power to unit 2. Mains cable damaged. Little or no airflow 1. Fan motor burnt out 2. Dirty refrigeration coils 3. Loose electrical wiring Little or no water extraction 1. Insufficient air flow 2. Compressor fault 3. Loss of refrigerant gas Little or no defrost when required 1. Faulty timer 2. Faulty reversing valve Unit vibrates excessively 1. Loose compressor 2.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 RM4500 SPARE PARTS LIST NUMBER 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 DESCRIPTION Timer Condenser coil Evaporator coil Filter Capillary Solenoid valve Filter dryer Solenoid coil Hour meter On/Off switch Power Relay Run capacitor Pump purge switch Fan Fan inlet ring Duct attachment Grille Wheel Condensate pump Compressor Heat exchanger Humidity Controller Page 9 of 12 PART NUMBER 1619508 2057025 2057024 2057031 3014249 3020833 3020957 30304
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 WARNINGS This appliance can be used by children from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the application in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 Page 11 of 12
Drawing : - TPC448 Issue :-3 Date : - 24/11/16 UK Head Office American Sales Office German Sales Office Ebac Industrial Products Ltd St Helens Trading Estate Bishop Auckland County Durham DL14 9AD Ebac Industrial Products Inc 700 Thimble Shoals Blvd. Suite 109, Newport News Virginia, 23606-2575 USA Ebac Industrial Products Ltd. Gartenfelder Str.
