Manual

≥
0.3m
≥
0.5m
≥
0.3m
≥
0.8m
6. Preparation before use
A.Position of the dehumidifier: Place the dehumidifier in themiddle of a room
away from walls which shows below:
4
8. Maintenance
Warning: please cut the power before maintenance.
A: Clean air filter
Ash on the filter will block the air hole, and it will impact the performance of
dehumidifier. So filter is needed to clean regularly.
If the machine is used in a place which have lots of ash, you must clean it
every 1~5 days.
If the machine is used in a clean place, you can wash the filter every one
month.
filter
pull out from
the left side
The way of washing filter：
a、Pull the filters out.
b、 Using cleaner to wash the ash on filter. You can also use warm water
(below 40 ) to wash filter
c、Dry the filter after washing then install it back to machine.
Note: Do not broil the filter or put it under sunshine.
B、Check drain hose:
An unimpeded drain hose can assure the drainage of water, so it is
necessary to check the hose in case of obstruction. If the hose is deflated
and can’t recover, you must replace a new pipe.
C、 If do not use the machine for a long time, please drain the inner water
and pull out the power supply.
D、Do not operate dehumidifier near heat source like burner, heater, or this
can cause damage to both person and machine.
E、 Do not use dehumidifier on the place where water may spatter to
machine.
F、Before using, the machine should be put steadily to avoid damage.
℃
7
1、“ON/OFF”: Press once to turn the unit on or off.
2、 “ UP and Down”: For setting humidity, it will grow or reduce 1% by
pressing it once. If no operation in 5s, the setting will be completed.
3、”T”: display working hours and totally working time
After turning on operation, it can display setting humidity(left) and current
humidity(right), and humidity could be changed by pressing “Up and Down”.
for the current time, and the time unit is based on minutes, for example, if it
displays “0000:50”, it means that it has worked for 50 minutes this time. If
you want to view the totally working time, please press “T” once more, and it
will shows for 10s and returns automatically to the original working hours. If
you press “T” before it has lasted for 10s, it also can turn to the original
working hours.
If the unit is in power but not in operation, LED will displays nothing, and in
this condition, the working hours at the last time will be showed for 10s if “T”
is pressed one time. But within 10s, if “T” is pressed again, the totally
working time will be showed for also 10s, and within 10s, if there is no
action, LED will automatically turn down. In addition, if “T” is pressed again
when LED displays the totally working time, LED will turn down
immediately. What's more, the current working time will be deleted by
pressing “T” for 5s continuously, and the time will be recounted, but the
deleted time will be added into the totally working time.
4、 “ PURGE”: Press the PURGE key to empty water from the pump
reservoir. The pump will close automatically after forty seconds continuous
operation. During normal operation, the pump purges automatically when
the reservoir is full. And during purge condition, if the bottom is pressed
once again, the pump will stop draining. Please press “PURGE” to make
drainage before moving the machine to avoid water spillage.
Note: The totally working time can not be deleted, if the time is beyond the
range of LED showing time, it will be deleted and recount from the start.