User`s manual
Table Of Contents
- eClient 630L/630L-N User's Manual (for Administrator) Version F
- User’s Manual Version List
- SAFETY SYMBOLS
- TABLE OF CONTENTS
- 1. INTRODUCTION
- 2. CONNECTING THE eClient 630L/630L-N
- 3. SETTING UP the eClient 630L/630L-N
- 4. ADDING & CHANGING A CONNECTION NAME
- 5. LOGON & LOGOFF
- 6. USING THE TERMINAL PROPERTIES
- 7. SOFTWARE UPDATING/INSTALLATION
- 8. PRACTICAL SETUP
- 9. TROUBLESHOOTING
- 10. CLEANING
- 11. SPECIFICATIONS
- 12. REFERENCE
- INDEX
[Single Button Connect Enable]
...................................(Select the [Terminal Security Enable] check box to
enable this check box.)
The procedure to connect to the WTS can be restricted.
When this check box is selected, the “Single Button
Connect” dialog box is displayed when the eClient
630L/630L-N starts up.
Clicking [Connect] in the “Single Button Connect”
dialog box, the selected connection in the [Startup…]
(see page 23) of “Terminal Connection Manager”
starts up.
(“Terminal Connection Manager” is not displayed.)
Canceling Settings
(1) Display the “Single Button Connect” dialog box.
(2) Press [Alt] and [F4] keys at the same time.
(3) “Enter Security Password” dialog box is displayed. Enter the password set in
the [Password] of the [Control Panel].
(4) “Terminal Connection Manager” is displayed.
NOTE
• Terminal Security cannot be canceled by this setting.
Administration Console
[Administration Console]
...................................Assign an IP address of a server with the Network
Administrator. Other servers with the Network
Administrator will not be able to control the eClient
630L/630L-N after setting the administration console.
48 6. USING THE TERMINAL PROPERTIES