User Manual

- 43 -
Chapter 6 Reference
Attachment procedure
1.
LaytheLCDmonitoronasoftclothspreadoverastableandatsurface
with the panel surface facing down.
2.
Remove the stand.
Prepare a screwdriver.
Use the screwdriver to loosen the screws (four) that secure the unit to the stand.
3.
Attach the arm or stand to the monitor.
Secure the monitor to the arm or stand using the screws specied in the User’s Manual of the
arm or stand.
6-2. Detaching/Attaching Stand Base
Detachment procedure
The stand base that was attached during setup can be detached using the following procedures.
1.
Lay the LCD monitor on a soft cloth spread over on a stable surface with the panel surface facing down.
2.
Turnthexingscrewonthestandbasetodetachit.
Note
• The xing screw can be removed by hand. If the xing screw is too tight, use a coin or athead screwdriver.