User`s manual

26
Chapter3SettingMonitor
3-8. Setting the Input Signals “Signal Selection”
Signals can be selected based on your operating environment.
Attention
• The graphics board supporting signal display is required.
• Refer to the User’s Manual of the graphics board.
●
To connect DVI (Single Link)
Procedure
1. Press
to turn off the monitor.
2. Holding
down, press for at least two seconds to turn on the monitor.
The “Optional Settings” menu appears.
3. Choose “Signal Selection” from “Optional Settings”, and press .
4. Select “DVI” with
or , and press .
5. Select “Signal Format” with
or , and press .
6. Select “Single Link” with
or , and press .
7. Press
twice.
8. Select “Finish” with
or .
9. Press
.
The “Optional Settings” menu is closed.
●
To connect DVI (Dual Link)
Procedure
1. Press
to turn off the monitor.
2. Holding
down, press for at least two seconds to turn on the monitor.
The “Optional Settings” menu appears.
3. Choose “Signal Selection” from “Optional Settings”, and press .
4. Select “DVI” with
or , and press .
5. Select “Signal Format” with
or , and press .
6. Select “Dual Link” with
or , and press .
7. Select “Signal Bandwidth” with
or , and press .
Use or to select or just conrm the signal bandwidth setting for the frequency that corresponds to your graphics
board.
Setting
Horizontal scan frequency
(kHz)
Vertical scan frequency (Hz)
Normal 26to89 59to61
Wide 26to89 23.75to63
8. Press .
9. Press
twice.
10. Select “Finish” with
or .
11. Press
.
The “Optional Settings” menu is closed.