User`s manual

15
Chapter 2 Settings and Adjustments
2-11 Beeper Setting
●
To set the beeper [Beep]
Set the beeper on/off for operation tone of the switches, connection error, etc.
Sound type Conditions for beeping
Short beep • When
-/$%
is pressed.
• When an item is selected with
.
• When a maximum or minimum value is set with
the control switches.
• When
is pressed.
Long beep
• When registration is performed with
.
Consecutive beeps • When the monitor is not connected correctly.
• When the PC is not turned on.
• When no signal is received.
• When a frequency out of the specied range is
received.
Beep-beep once every 15
seconds
• 15 minutes before the power off time set by “Off
Timer” (advance notice time)
(1) Choose <Others> from the Adjustment menu, and press .
(2) Choose <Beep> from the <Others> menu, and press .
The <Beep> menu appears.
(3) Select “On” or “Off” with or , and press .
The beep setting is completed.
2-12 Selecting Input Signal
●
To select input signal [Input Signal]
In single display mode, this function allows you to select the signal displayed
on the monitor.
Priority setting Function
Auto When either PC is turned off or enters the power-
saving mode, the monitor automatically displays
signals of another PC.
Manual The monitor does not detect the PC’s signals
automatically. Select an active input signal with .
(1) Choose <Others> from the Adjustment menu, and press .
(2) Choose <Input Signal> from the <Others> menu, and press .
The <Input Signal> menu appears.
(3) Choose <Auto/Manual> with or , and press .
NOTE
• Whentheinputsignalsettingis
“Auto” in single display mode, if
no input signal is received on both
SIGNAL1 and SIGNAL2 port, the
signal port selecting function is
performed at every two seconds.