User`s manual
Table Of Contents
- FlexScan T2351W User's Manual
- Cover
- CONTENTS
- Chapter 1 Introduction
- Chapter 2 Adjusting Screens
- 2-1. Compatible Resolutions/Formats
- 2-2. Setting the Resolution
- 2-3. Displaying Screen Correctly
- 2-4. Adjusting Color
- To select the display mode (FineContrast mode)
- To perform advanced adjustments
- Adjustable settings in each mode
- To adjust brightness
- To adjust black level
- To adjust contrast
- To adjust color temperature
- To adjust gamma
- To adjust the color saturation
- To adjust hue
- To adjust gain
- To reduce image blur
- To set overdrive intensity
- 2-5. Changing the Screen Size
- Chapter 3 Setting Monitor
- Chapter 4 Power Saving Functions
- Chapter 5 Connecting Cables
- Chapter 6 Troubleshooting
- Chapter 7 Reference
- Appendix
41
Chapter7Reference
Chapter 7 Reference
7-1. How to Attach the Optional Arm
An optional arm (or an optional stand) can be attached by removing the stand section. Please refer to our web
site for the corresponding optional arm (or optional stand). http://www.eizo.com
Attention
• When attaching an arm or stand, follow the instructions of their user’s manual.
• When using another manufacturer’s arm or stand, conrm the following in advance and select one conforming to the
VESA standard. Use the M4 × 12 mm screws supplied with this product.
- Clearance between the screw holes: 100 mm × 100 mm
- Thickness of plate: 2.6 mm
Strong enough to support weight of the monitor unit (except the stand) and attachments such as cables.
• When using an arm or stand, attach it to meet the following tilt angles of the monitor.
- Up 65°, down 45° (for landscape display)
• Do not turn the monitor in the vertical direction.
• Connect the cables after attaching an arm or stand.
• The monitor and arm or stand are heavy. Dropping them may result in injury or equipment damage.
Procedure
1.
Lay the LCD monitor on a soft cloth spread over on a stable surface with the
panel surface facing down.
2.
Remove the stand.
Prepare a screwdriver. Loosen the screws (four) securing the unit and the stand with the screwdriver.