SAFETY SYMBOLS This manual uses the safety symbols below. They denote critical information. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates a mandatory action that must be followed. Copyright© 2006 EIZO NANAO CORPORATION All rights reserved.
TABLE OF CONTENTS PRECAUTIONS ............................................................................................4 1. INTRODUCTION ...........................................................................................6 2. CONTROLS & CONNECTORS ....................................................................7 3. INSTALLATION .............................................................................................8 4. SPEAKERS & SOUND CONTROL .............................................
PRECAUTIONS To ensure personal safety and proper maintenance, please read this section and the caution statements on the unit (refer to the figure below). [Location of the Caution Statement] ● Top view WARNING Keep small objects or liquids away from this product. If small objects or liquid accidentally enters into this product, fire, electric shock, or equipment damage may result.
CAUTION When adjusting the viewing angle of the monitor, do not grasp the sound unit. Adjusting the monitor by grasping the sound unit may dislodge it from or tip over the monitor, and may result in injury or equipment damage. Remove the sound unit whenever moving the monitor. Moving the monitor with the sound unit attached is dangerous. It may result in injury or equipment damage. Attach only to specified EIZO LCD monitors.
1. INTRODUCTION Thank you for choosing the EIZO i·Sound™ L3 sound unit. Package Contents Please contact your local dealer for assistance if any of the listed items are missing or damaged. Please retain the packing materials for future transport of this product. i·Sound L3 Sound Unit ...........................1 USB Cable (MD-C93) ..............................1 User’s Manual .........................................
2. CONTROLS & CONNECTORS ● Top view 1. USB upstream port When this port is connected to a downstream port of a PC, the PC provides sound and power. On/Off operation depends on the PC’s main power. 1 ● Front view 2 3 2. Headphones jack Connect headphones to this jack to hear the sound from the headphones. When using the headphones, no sound is output from the speakers. 3. Volume control dial Use to adjust the sound level from the speakers or the headphones. 4.
3. INSTALLATION 1. Check the mounting positions of the monitor and the sound unit shown below.
2. Attach the sound unit to the monitor. 1. Attach the sound unit to the monitor. Place the sound unit under the monitor screen and insert the hook 1 on top of the unit into the slot 1 located at the bottom rear of the monitor. 2. Slide the unit to the left until you hear it clicks. Then hook 2 will snap into slot 2. 1 NOTE 2 • To remove the sound unit from the monitor At the rear of the monitor, hold the unit with both hands and slide the sound unit to the right and pulling hook 2 out.
3. Connect the USB cable to the sound unit. Connect the USB downstream port of a PC to the USB upstream port of the sound unit using the USB Cable.
4. SPEAKERS & SOUND CONTROL 1. See the volume setting of your PC. If you use Windows OS, maximize the volume control of the PC. 2. Use the volume control dial of the sound unit to adjust to the desired sound level. NOTE • To use headphones Connect the plug of the headphones to the headphones jack of the sound unit. (When headphones are connected, no sound can be heard from the speakers.
5. TROUBLESHOOTING If a problem persists even after applying the remedies suggested below, contact an EIZO dealer. Problem Points to check and possible solutions 1. No sound □ Check that the USB cable is correctly connected. □ Check that the PC is turned ON. □ Check the settings of the PC and the audio playback software. □ Check that the volume of the sound unit is correctly set. □ Check that the audio playback mode of the PC is not set to “Analog”. If it is set to “Analog”, sound may not be output.
6. CLEANING Periodic cleaning is recommended to keep the sound unit looking new and to prolong its operation lifetime. To remove stains, wipe the unit with a soft, lightly moistened cloth using a mild detergent. NOTE • Never use thinner, benzene, or other strong solvents or abrasive cleaners to clean this product, as these may cause damage.
7. SPECIFICATIONS List of Specifications Speakers Speaker System Amplifier Output (min.) Frequency Response Interface Control Power Supply Power Consumption (max.) OS Dimensions Weight Environmental Conditions 14 4 cm x 2.8 cm (two) Stereo system with built-in amplifier 0.9 W + 0.9 W 200 Hz ~ 20 kHz USB Specification Rev 1.1 Volume Control 5V±5% (supplied from USB port) 2.
Dimensions mm (inch) 15
LIMITED WARRANTY EIZO NANAO CORPORATION (hereinafter referred to as “EIZO”) and distributors authorized by EIZO (hereinafter referred to as the “Distributors”) warrant, subject to and in accordance with the terms of this limited warranty (hereinafter referred to as the “Warranty”), to the original purchaser (hereinafter referred to as the “Original Purchaser”) who purchased the product specified in this document (hereinafter referred to as the “Product”) from EIZO or Distributors, that Product shall be free
For U.S.A, Canada, etc. (rated 100-120 Vac) Only FCC Declaration of Conformity We, the Responsible Party EIZO NANAO TECHNOLOGIES INC. 5710 Warland Drive, Cypress, CA 90630 Phone: (562) 431-5011 declare that the product Trade name: EIZO Model: i·Sound L3 is in conformity with Part 15 of the FCC Rules.