Installation Guide

installation instructions:
electric drill
drill bit for pilot hole
countersink bit
lag screws & washers
putty knife
wood putty
sand paper
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• Brackets can be heavy and/or awkward to hold. We recommend nding help
when placing the bracket in place.
• Be sure to mark the placement of the bracket before fastening in place. It is
recommended that you fasten the bracket to a post or beam.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
1. Mark placement of screw holes using a pencil or maker
2. Drill a pilot the hold using a the proper sized drill bit for you lag screw.
3. If you wish to countersink the screws, use the countersink bit to drill a
hole deep enough to hide the head of the screw.
4. Using the pilot hole fasten the bracket to the installation are making sure
that the screws lock into a post or beam.
5. Fill in the screw holes with wood putty and sand to nish
POST
SIDING/PLYWOOD
LAG SCREWS & WASHERS
RUSTIC BRACKET/CORBEL