Instructions / Assembly

www.ekenamillwork.com · Phone: [phone] · Fax: [phone] · [e-mail]
Endurathane Wall Panels
Installation Guide
Adhesion Fastening
Interior & Exterior Cement/Masonry Substrates
PL® Premium Polyurethane Construction Adhesive is a one component, polyurethane based, moisture-curing adhesive.
It is VOC compliant and contains no chlorinated solvents or water. PL® Premium provides superior adhesion to most
common construction materials. It can be used for interior or exterior projects and is three times as strong as conven-
tional solvent based construction adhesives. It is also waterproof, paintable and cures even in cold temperatures. Ideal
for sub oor installations, bonds most common construction materials such as concrete, stone, marble, slate, masonry,
brick, cement-based products, ceramic, berglass.
Tools Required
Circular saw or table saw, jigsaw or sabre saw, level, measuring tape, chalk line, power or cordless drill, 4” drill bits or
extension, framing square or speed square, wood rasp utility knife, caulking gun, trowel, tool to puncture cartridge seal,
plant mister bottle containing water and PL® Premium Polyurethane Construction Adhesive.
Preparation
Use above 40°F (4°C). Surfaces must be clean, dry and free of frost, grease, dust and other contaminants. Pre-t all
materials and protect nished surfaces. If using cartridge format, cut nozzle at a 45° angle to desired bead size and
puncture inner seal. Be very careful not to allow PL® Premium to cure on a nished surface.
Application
Apply adhesive to one surface of the material being bonded. Press the surfaces rmly together. Materials may be repo-
sitioned within 45 minutes after applying the adhesive. If bonding two non-porous surfaces (such as foam, metal and
berglass), add water in the form of a very light or atomized spray from a plant mister bottle to the extruded adhesive.
The repositioning time will then be reduced to less than 30 minutes. Use mechanical support for 24 hours while the
adhesive cures.
Clean-up
Clean tools and uncured adhesive residue immediately with mineral spirits in a well-ventilated area to the outdoors.
Remove cured adhesive by carefully scraping with a sharp-edged tool.