Installation Guide

CAPITAL/PLINTH/BASE

installation instructions:

TOOL & MATERIAL

CHECKLIST

SAFETY INSTRUCTIONS

SPECIAL INSTRUCTIONS

AND NOTES

STEP BY STEP

INSTRUCTIONS

EXAMPLE

INSTALLATION DIAGRAMS

• It is highly recommended that you paint/nish our capitals and bases before

you install them. Once installed, you can apply any necessary touch‐up paint/

nish.

• Clean installation surface and back of all dirt and dust with a clean cloth or

sponge.

• Make sure that the surface and the back are completely dry before attempting

installation.

• Measure and mark the location where the cap or base is going to be installed.

1. Lay the capital, plinth or base face down on

a soft surface that will not scratch/dent the

surface detail.

2. Apply small bead of construction adhesive

all the way around the back edge of the

product you are installing.

3. Line up the capital edge with the top edge

of the pilaster and the base edge with the

bottom edge of the pilaster for seamless

installation.

4. When pressing the capital, plinth or base

up against the installation surface, some

adhesive may seep out, wipe away excess

adhesive around the edge with nger or rag.

5. Secure with nishing nails for additional

support.

construction adhesive

rag

nail gun

nishing nails

extra ne sandpaper

Make sure to use the correct tools recommended.

Wear proper protective gear.

Follow xture, power tools, paint manufacturers’ instructions, and users manuals.

Use common sense and follow good construction practices.

CONSTRUCTION ADHESIVE