Installation Guide

ManualsBrandsEkena Millwork ManualsBuilding materials20 in. Inner Tee for 8 in. Deluxe Coffered Ceiling System

Coffered Ceiling

installation instructions:

Power Grab Adhesive

Utility Knife, Circular Saw, or Table Saw

Paint Brush or Roller

Measuring Tape

Sand Paper

STEP BY STEP

INSTRUCTIONS

TOOL & MATERIAL

CHECKLIST

SPECIAL INSTRUCTIONS

AND NOTES

EXAMPLE

INSTALLATION DIAGRAMS

Thoroughly read through the installation instructions to familiarize yourself before beginning.

Acclimate the products for 24 hours to the room before installing.

It is recommended that a complete layout be planned before cutting or installing. Take into

consideration vents, xtures, re sprinklers, lighting, etc.

Before installing ensure the product is free of any debris or dust.

SAFETY INSTRUCTIONS

Make sure to use the correct tools recommended.

Wear proper protective gear.

Follow xture, power tools, paint manufacturers’ instructions, and users manuals.

Use common sense and follow good construction practices.

1. Prepare installation surface with sandpaper by remov-

ing excessive bumps or texture. Wipe clean and apply

primer to ensure proper adhesion.

2. Mark center points on each side of the ceiling. (Fig. A)

3. Measure from the center to mark placement of the

perimeter tee pieces. (Fig. B)

4. Connect each mark using a chalk line. (Fig. C)

5. Install corner pieces using adhesive and nishing

nails. (Fig. D)

6. Install perimeter tees using adhesive and nishing

nails, centering them on the chalk markings. (Fig. E)

7. Install intersection piece using adhesive and nishing

nails, centering on the chalk markings. (Fig. F)

8. When installing perimeter beams make sure to mea-

sure for each space and cut according to that space,

then install using adhesive and nishing nails. Apply

adhesive to the backs and ends of the perimeter beam

pieces. (Fig. G)

9. When installing inner beams make sure to measure

for each space and cut according to that space, then

install using adhesive and nishing nails. Apply adhe-

sive to the backs and ends of the inner beam pieces.

(Fig. H)

10. Once installed, paint your coffered ceiling as desired.

Fig. A

Fig. C

Fig. E

Fig. G

Fig. B

Fig. D

Fig. F

Fig. H