Other

may raise nuisance particles that can cause mechanical irritation to the skin, eyes, or respiratory tract.
Polyvinyl chloride dust accumulation can present a dust explosion hazard. Take necessary measures to limit dust
production, and follow applicable regulations. Wear gloves when cutting or fabricating sheet
Hygiene measures: Handle in accordance with good industrial hygiene and safety procedures. Wash hands and
other exposed areas with mild soap and water before eating, drinking, or smoking and again when leaving work.
Do not eat, drink or smoke when using this product.
7.2. Conditions for safe storage, including any incompatibilities
Storage conditions: Store away from incompatible materials. Store in a cool, dry, well-ventilated area, away from
sources of extreme heat or fire. Note: Electrical build up is possible.
Incompatible products: Strong acids. Strong bases. Strong oxidizers.
7.3. Specific end use(s)
Trim/Molding on the Exterior/Interior of buildings
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
The final product is considered an article and not hazardous in its final form under normal conditions of use according
to 29CFR 1910.1200. The ingredients contained within this product are not expected to be bioavailable under normal
conditions of use.
8.2. Exposure controls
Appropriate engineering controls
Personal protective equipment
: Provide adequate ventilation to minimize dust concentrations.
: Safety glasses. Gloves. Insufficient ventilation
(specifically with the accumulation of dust or vapors from molten product):
wear respiratory protection.
Materials for protective clothing
Not required for normal conditions of use. As necessary when
handling hot or molten sheet, wear protective clothing.
Hand protection
If handling hot or molten sheet wear insulated gloves, under
normal
conditions wear work gloves.
Eye protection
Chemical goggles or safety glasses when cutting or
fabricating the product
Respiratory protection
Use NIOSH-approved air-purifying or supplied-air respirator
where airborne
concentrations of dust or vapors from
molten product are expected to exceed exposure limits.
Other information
Use good personal hygiene practices. Wash hands before
eating, drinking, smoking or using toilet. Promptly remove
soiled clothing and wash thoroughly before reuse.
8. Exposure controls and personal protection