Specification
2
Architectural Specications
Ekena Millwork Polyurethane
3.2 Finishing
3.2.1 Ekena Millwork, Inc. products are supplied with a white or beige primer base coat, ready for nishing top coat. A good quality exterior
or latex or oil base paint may be used on rigid Ekena, Inc. product. The surface must be clean, dry, and free from all greases or waxes
before all nish work is begun.
3.3 Warranty
3.3.1 Ekena Millwork, Inc. warrants its Ekena urethane product upon the following conditions against defects in materials and workmanship
for the product’s lifetime when used and installed under recommended conditions.
Purchaser and installer must inspect each piece prior to installation. Both parties waive all defects which could have been discovered
by reasonable inspection prior to installation.
3.3.2 Warranty will automatically be void if Ekena installation methods are not used as per section on Installation.
3.3.3 In the event claim is made under this warrant, Ekena has the right to inspect the part and determine at their discretion, that the parts
supplied are defective. Ekena will repair, or if necessary, replace the defective parts if returned freight prepaid to Ekena place of
manufacturing. If Ekena determines the parts cannot be repaired or replaced, Ekena will refund to the distributor the amount paid to
Ekena for the said defective parts.
3.3.4 Ekena shall have no liability to any person, rm or corporation whatsoever for incidental or consequential damages such as but not
limited to, labor, nishing, parts damaged by freight carriers, freight charges, installation, lost prots, and lost sales or the like.
3.3.5 No purchaser may take any deduction or credit against any amount owed to Ekena or make any charge back without the expressed
written consent of Ekena.
3.3.6 No purchaser may take any deduction or credit against any amount owed to Ekena or make any charge back without the expressed
written consent of Ekena.