Installation Instructions

CROSSHEAD/PEDIMENT/PILASTER
installation instructions:
construction adhesive
elastomeric adhesive caulk
caulking gun
nishing nails
hammer
putty knife
extra ne sandpaper
tape measure
jigsaw or keyhole saw
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• It is highly recommended that you paint/nish our crosshead, pediment, or pilas-
ter before you install them.
• Once installed, you can apply any necessary touch‐up paint/nish.
• ‐Clean installation surface and back of crosshead, pediment, or pilaster of all dirt
and dust with a clean cloth or sponge.
• Make sure that the surface and the back of the crosshead, pediment, or pilaster
are completely dry before attempting installation.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
1. Lay the crosshead, pediment, or pilaster face down on a soft surface that will
not scratch/dent the medallion detail.
2. Apply a continuous 1/2” bead of adhesive caulk along the back.
3. Place the crosshead, pediment, or pilaster to your desired installation surface.
4. Align crosshead with the outer edges of the opening or pilasters. (Note: The
crosshead can be slightly larger than the opening as long as the overhang is
equal on both sides.)
5. Fasten using PL Premium Construction Adhesive and any necessary fasten-
ers.
6. Use a nger or putty knife to smooth any excess adhesive.
7. Use latex caulk to seal edges. Use a nger or putty knife to smooth caulk.
8. Touch up using a high quality latex paint.