Installation Guide

COMPOSITE SHUTTERS

installation instructions:

electric drill

1/8” & 1/4” drill bit

shutter harwardware

proper screws for installation surface

screw driver

level

pencil, marker, or chalk

TOOL & MATERIAL

CHECKLIST

IMPORTANT INFO

• Determine the position of the Pintel on the Window casement. Measure the depth of the

surface that the Pintel will be mounted on and the adjacent wall surface. This will determine

the Pintel height and Hinge combination that best ts the application.

• Shims are available to adjust the pinter projection.

SAFETY INSTRUCTIONS

Make sure to use the correct tools recommended.

Wear safety goggles.

Follow xture, power tools, and paint manufacturers’ instructions and users manuals.

Use common sense and follow good construction practices.

Decorative Hardware

1. Determine the position for the mounting brackets by matching up the top

and bottom of the shutter with the window and mark its position.

2. Using a level set the bottom bracket in place and fasten using the correct

screws for your installation surface. (Note: At this point it is recommend-

ed you place the shutter in place and double check your marking for the

top bracket.)

3. Using a level set the top bracket in place and fasten using the correct

screws for your installation surface.

4. If installing shutters larger than 55” fasten with center “L” brackets (A).

5. Set the shutter in place, mark the position of the holes on the shutter.

Remove the shutter and drill pilot holes using a 1/8” bit.

6. Place the shutters back in place and fasten the shutter in place using

screws being sure not to over-tighten the screws.

4 4

WINDOW