Installation Guide

PVC SHUTTERS
installation instructions:
electric drill
1/8” drill bit
caulk gun
exterior grade screws
putty knife
acrylic caulk
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• 1/8” carbide drill bit is required for stucco, hardboard, ber cement, brick or masonry.
• For shutters up to 55”, use four screws per shutter.
• For shutters over 55”, use six screws per shutter.
• Pre-nish shutters with 100% acrylic paint prior to installation.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
Decorative use only.
General Installation
1. Determine the position for the shutter by matching up the top and bottom of
the shutter with the window and mark its position.
2. Mark the shutter where you will fasten it to your installation surface by
drilling through the shutter to mark the facade at the top, middle and
bottom of the shutter.
3. Remove the shutter and pre-drill pilot holes through the facade.
Caulk each pre-drilled hole with a clear water proof and paintable sealant.
4. Using a level, set the shutter in place and fasten using non-corrosive
exterior grade screws. Be sure not to over-tighten the screws.
5. After shutters are securely fastened, cover the fastener with a compatible
acrylic ller or caulk, and touch up with your selected paint.
Finishing Tips:
1. Paint with premium grade exterior 100% acrylic paint.
2. Seal with exterior-grade clear acrylic top coat.
We Can Help. Call [phone]
www.ekenamillwork.comIndustry leading manufacturer of urethane, PVC, wood, rustic, and metal millwork