Installation Guide

SHUTTER LOK PLACEMENT
INSTALL INSTRUCTIONS
Shutters Smaller
Than 47”
* Shutters smaller than 47”
require 4 shutter loks
Shutters Larger
Than 47”
* Shutters larger than 47”
require 6 shutter loks
1. Place shutter next to window in desired location.
2. Shutters with heights through 47” require 4 fasten-
ers per shutter as shown on the shutter to the left.
Shutters over 47” in height require 6 fasteners per
shutter as shown in the picture to the left.
3. Drill 1/4” diameter holes 3” deep at locations shown
in step 2. When installing on any horizontal siding
locate the hole so that you drill the siding at its high
point. (Drill within 1” of the point at which the siding
contacts the shutter.) See pictures for steps #3 and #4
clarification.
4. Insert fastener in hole in shutter and tap through the
shutter and into the wall. Do not hit any harder than is
necessary to seat it.
5. Make sure that the fastener is snug against the
shutter at all points as to not dimple the shutter.
3”
[phone]
EKENAMILLWORK.COM
CONTACT:
VINYL SHUTTER INSTALL
Painting:
The color of these shutters is guaranteed for 40 years
not to chip, flake, or discolor. To achieve this the color
has been molded into the shutter, making it unpaint-
able unless paintable(030 Paintable) shutters were
ordered. For finishing paintable shutters use Sherwin
Williams Duration or Superpaint.