Installation Guide

Shutter Clip
REQUIRED FOR INSTALLATION:
Screwdriver, electric drill, level and pencil. (4) shutter clips for shutters up to 43" and (6) shutter clips
for shutters 44" or greater. Also needed are (9) No. 10 or equivalent (M5 metric) screws. Other fasteners
may be needed for specific surfaces (not included).
STEP 1
Push a shutter clip onto the ribs at each corner
of the shutter. The mounting tab should extend
beyond the shutter. See Figure 2. Shutter clips
will be removed later, so DO NOT fasten shutter
clips completely onto the shutter at this time.
Correct
Placement for
Shutter Clips
Do not completely
fasten Shutter Clips
to shutter at this time
Figure 1
Figure 2