Installation Guide

RUSTIC BRACE/OUTLOOKER
installation instructions:
electric drill
drill bit for pilot hole
countersink bit
lag screws & washers
putty knife
wood putty
sand paper
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
Because of the wide variety of sizes, weights, applications, and building codes
these installation instructions are to be used as a reference and not as the
recommended methods. The installer should be sure to use common sense and
good construction practices. If there is any uncertainty about how to install this
product consult a professional.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
1. Mark placement of screw holes using a pencil or maker
2. Drill a pilot the hold using a the proper sized drill bit for you lag screw.
3. If you wish to countersink the screws, use the countersink bit to drill a
hole deep enough to hide the head of the screw.
4. Using the pilot hole fasten the brace to the installation are making sure
that the screws lock into a post or beam.
5. Fill in the screw holes with wood putty and sand to nish.