Installation Guide

CROSSHEAD/PEDIMENT
installation instructions:
construction adhesive
elastomeric adhesive caulk
caulking gun
nishing nails
hammer
putty knife
extra ne sandpaper
tape measure
jigsaw or keyhole saw
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• It is highly recommended that you paint/nish our crossheads before you install
them. Once
• installed, you can apply any necessary touch‐up paint/nish.
• ‐Clean installation surface and back of crosshead of all dirt and dust with a clean
cloth or sponge.
• Make sure that the surface and the back of the crosshead are completely dry
before attempting installation.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
Medallions are not load‐ bearing. Do not use them to support electrical xtures or ceiling fans.
1. Lay the crosshead face down on a soft surface that will not scratch/dent the
medallion detail.
2. Apply a continuous 1/2” bead of adhesive caulk along the back of the cross-
head.
3. Place the crosshead on top of the entrance opening.
4. Align crosshead with the outer edges of the opening or pilasters. (Note: The
crosshead can be slightly larger than the opening as long as the overhang is
equal on both sides.)
5. Fasten the crosshead using PL Premium Construction Adhesive and any
necessary fasteners.
6. Use a nger or putty knife to smooth any excess adhesive around the cross-
head.
7. Use latex caulk to seal edges around crosshead. Use a nger or putty knife to
smooth caulk.
8. Touch up crosshead using a high quality latex paint.