Installation Guide
![](/manual/ekena-millwork/rwl18x025cgp/installation-guide-english/images/img-1.png)
WOOD SHUTTERS
installation instructions:
electric drill
1/8” drill bit
proper screws for installation surface
level
pencil, marker, or chalk
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• Determine the position of the Shutter in relation to the Window.
• Be sure to purchase the correct screws for your installation surface.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
Decorative Hardware
1. Determine the position for the shutter by matching up the top and bottom
of the shutter with the window and mark its position.
2. Mark the shutter where you will fasten it to your installation surface. (If
installing larger shutters fasten on the right a left hand side in the center
of the shutter.)
3. Using a 1/8” bit drill pilot holes where you marked the shutter.
4. Using a level set the shutter in place and fasten using the correct screws
for your installation surface. Be sure no to over-tighten the screws.