Installation Guide

Shelves
Our shelves are truly unique in design and function. Primarily used in decorative applications, urethane
shelves can make a dramatic difference in kitchens, bathrooms, entryways, fireplace surrounds, and
more. Urethane is also perfect for exterior use. It will not rot or crack, and is impervious to insect
manifestations. It comes to you factory primed and ready for your paint, faux finish, gel stain,
marbleizing and more.
Tools & Materials Needed
• Caulking gun
• Elastomeric adhesive caulk
• Sponge or clean cloth
• Putty knife
• Extra fine sandpaper
• Hammer & finishing nails
• Polyurethane construction adhesive (PL Premium recommended)
Prior to Installation
• It is highly recommended that you paint/finish our shelves before you install them. Once
installed, you can apply any necessary touch-up paint/finish.
• Clean installation surface and back of shelf of all dirt and dust with a clean cloth or sponge.
• Make sure that the surface and the back of the shelf are completely dry before attempting
installation.
• Measure and mark the location where the shelf is going to be installed.
Important Safety Instructions
• Make sure to use the correct tools recommended.
• Wear safety goggles.
• Follow fixture, power tools, and paint manufacturers' instructions and users manuals.
• Use common sense and follow good construction practices.
• Urethane shelves are not load-bearing. Do not use them for support.
Installation Process
1. Lay the shelf face down on a soft surface that will not scratch/dent the bracket detail.
2. Apply a 1/2" bead of adhesive caulk all the way around the back edge of the shelf.
3. When pressing the shelf up against the surface, some adhesive caulk will seep out. Smooth
excess caulk around the shelf with a finger or the putty knife and apply extra caulk that is
needed to fill in any gaps.
4. Wipe off any excess adhesive caulk with a sponge or damp rag.
5. Finishing nails may be used for added support. If used, fill in any nail holes with caulk and
smooth the surface with a finger. Let any excess caulk dry. Once dry, lightly sand with extra fine
sandpaper.
6. Touchup shelf with touchup paint as needed.