Instructions / Assembly

EnduraPanels
installation instructions:
Contact Adhesive
Utility Knife, Circular Saw, or Table Saw
Paint Brush or Roller
Measuring Tape
Sand Paper
Sheetrock Compound (Optional, see instructions.)
Putty Knife (Optional, see instructions.)
STEP BY STEP
INSTRUCTIONS
TOOL & MATERIAL
CHECKLIST
SPECIAL INSTRUCTIONS
AND NOTES
EXAMPLE
INSTALLATION DIAGRAMS
• Thoroughly read through the install instuctions to familiarize yourself with the process
bfore beginning installation.
• Before installing, acclimate the panels in the room where you will be installing them.
• In most applications you will have to trim some panels. Cut them with a standard utility
knife or power tool, such as a table saw. Sand cut edge to remove debris.
• Depending on your installation, you will have to choose the correct adhesive.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear proper protective gear.
Follow xture, power tools, paint manufacturers’ instructions, and users manuals.
Use common sense and follow good construction practices.
1. Prepare installation surface with sandpaper by
removing excessive bumps or texture. Wipe
clean and apply primer to ensure proper adhe-
sion.
2. Mark the installation points using a straight edge
and level.
a. On a wall with one corner start at the end wall
and work towards the corner (Diagram A)
b. For a wall with two corners start at the center
and work out (Diagram B)
3. Apply adhesive to the back of the panel and the
installation area. (Follow adhesive manufactur-
er’s instructions for proper application)
a. Install panels side by side. (These panels are
designed to minimize the appearance of
seams.) (Diagram C)
b. For a seamless appearance, leave a 1/16 inch
gap between each panel. After the panels have
dried, apply a layer of primer over the surface.
Once the primer has dried, go over the seams
with sheetrock compound. This may take two
or more applications. Be sure to sand between
each application. (Diagram D)
4. Once installed, you can leave the product with
its’ white factory nish, or prime and paint any
desired color.
Diagram A
Diagram C
Diagram B
Diagram D