Use and Care Manual

WOOD WALL TILES
installation instructions:
Polyurethane glue (3 tubes per 100 sq. ft.)
Saw (miter saw, a jigsaw, a table saw)
Pneumatic Nail Gun/Nails
Power drill or hammer
Fine sandpaper
Level (laser recommended) and tape measure
Ladder
STEP BY STEP
INSTRUCTIONS
TOOL & MATERIAL
CHECKLIST
SPECIAL INSTRUCTIONS
AND NOTES
EXAMPLE
INSTALLATION DIAGRAMS
• Before installing, acclimate wood tiles for at least 72 hours in the room where you will be
installing them.
• Depending on your installation method, you will have to choose the correct adhesive, but
we recommend quality polyurethane glue and small nails.
• In most applications you will have to trim some tiles. Cut them with a standard power
tool, such as a table saw. Sand cut edge to remove debris.
• Before installing on the wall, place the tiles side-by-side on the floor and arrange them to
balance out the color and grain pattern.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear proper protective gear.
Follow power tool and adhesive instructions, and users manuals.
Use common sense and follow good construction practices.
1. Smooth installation surface with sandpaper by
removing excessive bumps or texture. Wipe wall
clean to clear debris.
2. Remove the existing trim and electrical outlet
covers from the wall area that you will be work-
ing on and wipe the wall with a clean cloth to
remove any dust.
3. Measure the height of the wall for proper tting
as wall tiles may need to be cut to ensure proper
t. The rst and last panel in each row will need
to be trimmed to create a nished, even edge.
Use a laser level to create a reference line to
make sure the rst row is level.
4. Always start by installing the rst panel at the
bottom left corner of the wall working to the
right.
5. Apply adhesive to the back of the tile and press
against the wall. You can choose to secure with
nails by nailing through wood tile into studs
in the wall. (Follow adhesive manufacturer’s
instructions for proper application) Interlocking
end joints allow for seamless installation.
We Can Help. Call [phone]
www.ekenamillwork.com
Industry leading manufacturer of urethane, PVC, wood, rustic, and metal millwork
Polyurethane glue on back of tile
Start rst panel at the bottom left corner of the
wall working to the right.