Operation Manual

4
DATE and TIME SETTINGS
- Set the correct date and time before making a measurement.
- Date and time should be reset after replacing batteries.
1. Press and hold the “ AVG” button for a few seconds until
the “Year” digit ashes.
2. Press the“sMEMO” or “PAGEt” buttons to select the current year.
3. Press the “ AVG” button to conrm the year setting.
4. Follow the same steps to set the month, day, hour and minute.
5. You can choose to have the clock function “ON” or “OFF” while the
monitor is not in use. Press “sMEMO” or “PAGEt” button to
select. Press the “ AVG” button to conrm.
Note: If you select clock function “ON”, you should continue to the
“alarm setting” section. Otherwise, setting will not register.
ALARM SETTINGS
Note:
- You will not be able to set alarm if clock function is set to “OFF”.
- You can set a maximum of 4 alarm times.
6. To disable the alarm, press the ”sMEMO ” or “PAGEt” button to
select “OFF” and press the ” AVG” button to conrm.
7. To set 1st. alarm time, press the”sMEMO” or ” PAGEt” button
and select “ON”. Press the ” AVG” button to conrm.
8. When the hour digit ashes, press the“sMEMO” or “PAGEt”
button to select the hour. Press the “ AVG” button to conrm.
9. When Minute digit ashes, press the“sMEMO” or “PAGEt”
button to select the minute. Press the “ AVG” button to conrm.
10. Follow the same steps to set the 2nd, 3rd, and 4th alarm.
Note:
- if an error occurs press the “ ” button at any time during clock/
alarm setting to start again.
- Each alarm ringing lasts 45 seconds. You can turn it o by pressing
the “ ” button.