Datasheet

CC 121: Compact design and dynamic sound

The CC 121 is the ideal

centre channel loud-

speaker suitable for use

with FS 127 and BS 123

in a home cinema setup.

This compact centre

loudspeaker is designed

to fit most Hi-Fi/AV racks.

As this unit is magneti-

cally shielded, it can be

mounted directly on the

television without

affecting the picture

quality. Due to the wide

dispersion of this loud-

speaker, the traditional

‘sweet spot’ is eliminated,

allowing the movie

dialogue to be heard by a

wider audience.

Features and Benefits:

• This unique 2 ½-way loudspeaker offers wide dispersion of the movie dialogue, which is unob-

tainable using conventional 2-way design.

• To improve the performance of the system the cabinet is internally reinforced in a way that

eliminates internal standing waves and unwanted resonances.

• The CC 121 uses the latest generation of ELAC’s 25 mm

aluminium dome tweeter, which has extra headroom. Dome

and voice coil are moulded as one single piece. The driver

therefore offers higher power rating and durability.

• The newly designed high gloss baffle with a diffraction free

surface increases the sound quality and improves imaging.

• Both 140 mm bass drivers using ELAC tried-and-tested

Aluminium sandwich technology allow distortion-free bass re-

sponse as the resonance of the membrane is minimised. This

is due to the composite cellulose and aluminium construction.

It goes without saying that all drivers are magnetically

shielded.

PAGE 1
CC 121: Compact design and dynamic sound The CC 121 is the ideal centre channel loudspeaker suitable for use with FS 127 and BS 123 in a home cinema setup. This compact centre loudspeaker is designed to fit most Hi-Fi/AV racks. As this unit is magnetically shielded, it can be mounted directly on the television without affecting the picture quality. Due to the wide dispersion of this loudspeaker, the traditional ‘sweet spot’ is eliminated, allowing the movie dialogue to be heard by a wider audience.
PAGE 2
• Due to the double flare design of the bass port, flow noise, even at high levels, is eliminated. • • A two-part bass control plug is provided that can partially or fully close the port, so the system can be adjusted for the room acoustics and speaker placement. To optimise the sound there are individual crossover networks for the high and low frequencies, which can be bi-wired using two pairs of cable or alternatively, for optimum performance, two amplifiers can be used in a bi-amped situation.