Owners Manual

Connections
Speaker Connections
1. Use 16AWG (max) 2-conductor stranded speaker wire for speaker connections.
2. Strip approximately 1/4 to 1/2 of an inch off the ends and twist the strands together so
there are no loose ends that can cause shorts.
3. Ontheamplierrearpanel,insertoneendofeachstripedspeakerwiresintotheprovided
plugandtightenthescrews.Ensurethatallspeakerwiresarermlyattachedtotheplug.
4. Conrmpolarity.(Redwireto+).
5. Repeatforleft,rightandcenterspeakers,+and-.
6. Conrmconnectionandpolarityforeachchannel:left,rightandcenter.
7. Connectthespeakerwirestotheappropriate+and-terminalsonthespeakers.
8. Conrmconnection,polarityandposition.
Figure 4 IS-AMP340 Speaker Connections
IS-AMP340 Rear Panel
SPEAKER OUTPUTS
R+
Red Wire
To Positive
Right Speaker
Red Wire
To Positive
Left Speaker
R- C+ C- L+ L-
Red Wire
To Positive
(Optional)
Center Speaker
ELAC IS-AMP340 | www.elac.com | Page 10