Owners Manual

GUI Controls Dened
TheIS-AMP340amplierGUIcontrolpanelisshowninFigure 6.
Most of the GUI controls are simple and self explanatory, but some of them are described
below in detail.
Power On/Off - Usethiscontroltoselectthepoweron/offmode:
• Auto On/Off - Theamplierisdetectingtheaudiosignalanditisturningon/off
automatically.Ifthereisnoaudioforaprox.20min.theamplieristurnsoff.
• 12V Trigger - Requires 12V (>5 ... 24V DC)controlconnectedtotheamplier.Inthismode
the On/Off commands from IR remote and Ethernet will not work.
• Remote Control - InthismodetheampliercanbecontrolledviabothIRremoteand
Ethernet.
Volume Settings - Use this control to set the default master volume for selected input.
Input Default Volume - Will set the desired default volume for each input.
System Settings - Usethesecontrolstosettheamplieraccordingtoyouraudiospeaker
system.
Do you have a subwoofer [Check Box] - Select this option if you have a subwoofer. If the
audio signal is Dolby Digital
®
the sub frequencies are sent to the subwoofer.
Do you have a center channel [Check Box] - Select this option if you have a center speaker.
Use center with stereo source [Check Box] - This option will mix the left and right audio signals
and send it to the center speaker in addition to regular stereo audio signal in left and right
speakers, respectively.
Resetting the DHCP - The reset of the DHCP can be done via app.
IS-AMP340 GUI Control Panel (cont)
ELAC IS-AMP340 | www.elac.com | Page 13