Owners Manual

IS-AMP340 App
REMOTE LEARNING
The Remote Learning section allows the IS-
AMP340 to learn IR commands from other
remote controls. This can simplify user control
by teaching the amp commands from
another remote such as a TV remote so that
remote can be used to control the TV, IS-
AMP340 and other devices if capable.
When learning commands, be sure to use
commands that will make sense when
controlling the amp. Use volume up/down
commands for volume. Use source select
commands for source select functions. Use
transport functions for play/pause/previous/
next.
NOTE: The Play/Pause button is also a mute
button except when used in Bluetooth mode
where it is a pause/play command for a
synchronized Bluetooth device. So...a mute
command will mute/unmute the speakers
for all sources except Bluetooth where it will
pause/play the synchronized device.
1. In the source/Master Volume screen, tap
the Setup Gear in the upper right corner.
From the Setup Menu, tap Remote
Learning. The Remote Learning - Select
screen will appear.
2. Inthe‘Select’screentapabuttontobe
replaced with a new IR command. Follow
the cues on the amp front panel display.
‘Scanning’ will appear on the display.
3. Press the button on the remote to be
learneduntiltheampdisplayindicates:
‘Captured’.TheDisplaywillindicate‘OK’
if the code was learned.
4. When‘Again’appearsonthefrontpanel
display, press the SAME BUTTON on the
remote to be learned until the amp
againindicates:‘Captured’.
5. The amp will return to it’s previous
operating mode.
6. Press the button on the learned remote
to test the command to be sure the
command has been learned and is
affecting the proper function.
Figure 13 IS-AMP340 App -
Remote Learning - Select
Figure 14 IS-AMP340 App -
Remote Learning - Learn
ELAC IS-AMP340 | www.elac.com | Page 19