Spec Sheet

ELAC OW-V41L / OW-V41S ON-WALL Speakers | www.elac.com | Page 4

Ampliﬁer Terminals

Speakers Connection

After choosing the orientation of the speakers, do the following to avoid damaging the speakers:

• Ensure your equipment is turned o before connecting speakers.

• Use appropriate gauge wires (minimum of 16 gauge wire for runs up to 25 feet).

• Make sure wire polarity is connected correctly. Most speaker cables are coded for ease of use. Make

sure positive (red) connection on the ampliﬁer terminal is connected to the positive (red) on your

speakers. Follow the same instructions for the negative side. Strip o approximately 1/2”of the insulation

from the ends of the speaker cable, twist the bare strands and insert into the binding post.

• Check to ensure positive and negative wires are not touching each other once they’re connected to the

speaker terminals. See Fig.2.

Fig.2

Ampliﬁer Terminals

OW-V41L

OW-V41S

IMPORTANT !

Ensure the switch at the back of the speakers (OW-V41L model only) is in the correct position depending of the

orientation of the speakers: vertical or horizontal. See Fig.3.

Fig.3

Speaker Orientation

Switch

(OW-V41L model only)